| Power output level |
20Hz-20kHz, THD+N=0.1% 150W + 150W, RL=64 ohms (100V), RL=32 ohms (70V) |
| Power bandwidth |
Halfpower 10Hz-40kHz (THD+N=0.1%) |
| THD+N |
20Hz-20kHz, Half Power: 0.1% |
| Frequency response |
0dB, +0.5dB, -1dB f=20Hz-50kHz |
| Intermodulation distortion |
60Hz:7kHz, 4:1, Half power: 0.1% |
| Channel separation |
Half power, ATT. max input 600 ohm shunt: Greater than or equal to 65dB 20Hz-20kHz |
| Residual noise Att. Min: |
12.7kHzLPF = less than or equal to -65dB, IHFA network = less than or equal to -65dB |
| S/N Ratio |
100dB |
| Slew rate |
+/ - 35V/uS |
| Sensitivity (ATT. Max) Rated Power |
+4dBu (100V) + 1dBu (70V) |
| Voltage gain Att. Max |
38.2 dB |
| Input Impedance |
30k ohms (Balance), 15k ohms (Unbalanced) |
| Front Panel |
POWER switch (push on/push off) |
| Rear Panel |
Attenuator: (31 position dB calibrated) x 2, MODE switch (100V/70V), FILTER switch: LOW CUT x2 (-12dB/oct), HIGH CUT x2 (-6dB/oct) |
| Connectors |
Input: Barrier strip terminal XLR-3-31 type, Output: Barrier strip terminal |
| Indicators |
POWER (Green), PROTECTION x2 (Red), CLIP x2 (Red), SIGNAL x2 (Green) |
| Protection circuit |
POWER switch on/off mute; DC Detection; TEMP (heat-sink temp greater than or equal to 90 degrees C) |
| Fan Circuit |
Low speed (50 degrees C); variable, high speed (70 degrees C) |
| PC limiter |
RL less < or = to 16 ohms |
| Power requirements |
US and Canada model: 120V, 60Hz, Europe model: 230V, 50/60Hz, AT model 240V, 50/60Hz |
| Power consumption |
Idling: 45W; 1/8 Output power, 32 ohms: 350W; Maximum output, 32 ohms: 850W |
| Dimensions ( W x H x D) |
480x132x319mm (18-7/8" x 5-3/16" x 12-9/16"); Panel height 132mm, Depth behind front panel 319mm |
| Weight |
16kg (35.2 lbs.) |
